TROUBLESHOOTING YOUR GUITAR’S VOLUME CONTROL

Your electric guitar’s volume and tone controls are a fast, convenient way to raise and lower your guitar’s bass, mid, treble, and output volume without having to make adjustments at the amplifier; this is extremely helpful when practicing and performing, enabling you to tweak your tone and volume in the middle of a song.

When your guitar’s volume control fails the wires and connections need to be inspected. You’ll want to use your digital multimeter (DMM) to measure the resistance in ohms of the volume potentiometer. Potentiometers, or pots, are the electronic components to which the guitar’s volume and tone knobs attach. The problem with your volume control can be easily isolated and repaired with this simple three-step troubleshooting guide.

(Note: You’ll need a digital multimeter and small Phillips-head screwdriver. Ensure that your guitar is not plugged in to anything while testing your volume controls and, if you have any active electronics, remove their batteries.)

Step One

Remove all plates, knobs, and pickguards preventing access to your guitar’s electronics. Gibson-style guitars usually have a plate on the back of the body that covers the guitar’s electronics. Fender-style guitars, on the other hand, are generally accessed from the front, requiring you to remove the pickguard and the knobs attached to the potentiometers.

Step Two

Check the volume control pot’s wires and connections for any loose soldering or shorts. A loose or broken connection might be the source of the problem and this can be easily fixed by resoldering the connection with your soldering iron.

Step Three

Next you’ll want to test the volume pot using your digital multimeter. Set the DMM’s meter dial to 200k on the ohm (Ω) section of the dial and then turn the guitar’s volume control all the way in one direction. Touch the digital multimeter’s probes to the middle terminal and one of the outside terminals (potentiometers have three terminals). After that turn the volume control in the opposite direction. Depending on the direction the knob is turned the reading on your DMM will increase or decrease. If the reading on your DMM doesn’t change or even show up you’ll know the volume pot is no longer functional and will need to be replaced. The good news is that volume pots are inexpensive and need simply to be soldered.